|
To configure the PBX link on the DV2000/DV4, run System Configuration and select Features | Connectors from the main menu. In the Connectors dialog, select the IP Office | Devlink property page.
Configure the following settings:
Setting
|
Description
|
Enabled
|
Check this box to enable the DevLink connection.
|
Password
|
Enter the password used to communicate with the Avaya IP Office.
This is not the password used to administrate the system; it is the Monitor Password configured on the Unsecured Interfaces tab under security.
The default is to use the System Password, which by default is password.
|
IP Address
|
The IP address of the known Avaya IP Office. This setting is read-only. If the address is not correct, check your TAPI configuration settings in the Control Panel | Phone and Modem settings.
|
Additional servers
|
If more than one IP Office with DevLink is connected to the DV2000/DV4, enter the password and IP address for each additional link. Up to 8 additional links are supported.
These settings are optional and if not needed should be left blank.
|
|
