Navigation: Hospitality Administration > Hospitality Service > Configuration >

Set maintenance time

The hospitality service will perform a maintenance routine once per day, typically overnight, that will automatically set the maid status for all guest rooms to a specified status (typically Dirty or an equivalent value). This setting determines the time of day at which this process will occur.

To configure the maintenance time for the hospitality service, follow these steps:

1. Using Activity Monitor, stop the voice mail service.

MSC0108

2. Run the System Configuration application and select Features | Hospitality.

SYS0008

3. If prompted, select the PMS instance (as shown below). This dialog is only displayed if you are licensed for more than one PMS instance. Otherwise, skip to step 4.

SYS0076

4.	Select the General property page (located under PMS in the tree view on the left).

5.	In the section Service settings section, use the time selection box to set the time at which you want the maintenance process to occur.

HOSP0001f

6. Click Apply to save the setting without closing the dialog.

7. If you are finished configuring hospitality settings, click OK to save and close the dialog.

8. If the Hospitality Selection dialog was displayed in step 3, click Close to close it.

9. Once you are finished with all configuration changes, close System Configuration.

10. Using Activity Monitor, restart the voice mail service.

MSC0108