Navigation: Hospitality Administration > Hospitality Service > Configuration >

Enable the hospitality service

This setting determines if the hospitality service is allowed to run.

Note: On a typical system with only one server instance, this setting is always enabled and cannot be changed. You can only disable a server instance if your system is licensed to support multiple PMS instances.

To enable an instance of the hospitality service, follow these steps:

1. Using Activity Monitor, stop the voice mail service.

MSC0108

2. Run the System Configuration application and select Features | Hospitality.

SYS0008

3. If prompted, select the PMS instance (as shown below). This dialog is only displayed if you are licensed for more than one PMS instance. Otherwise, skip to step 4.

SYS0076

4.	Select the General property page (located under PMS in the tree view on the left).

5.	Check the box labeled Enabled to enable the service or uncheck the box to disable it. Then enter a brief description for the PMS instance in the box provided (such as the hotel name); this is optional but recommended.

HOSP0001a

6. Click Apply to save the setting without closing the dialog.

7. If you are finished configuring hospitality settings, click OK to save and close the dialog.

8. If the Hospitality Selection dialog was displayed in step 3, click Close to close it.

9. Once you are finished with all configuration changes, close System Configuration.

10. Using Activity Monitor, restart the voice mail service.

MSC0108