Set Password |
|
The set password function allows you to change the password for a guest room after it has been checked in. It can be performed via the PMS or via Mailbox Administration.
The default password for all guest rooms is 1234; when a mailbox is checked out, it will be reset to use that password.
Via PMSThe PMS sends a set password packet to the VMS that contains, at minimum, the room number and the new password. Most PMS protocols do not support this packet type, although some do. In some cases, the protocol may support specifying a password as part of the check in packet even if they do not support a separate set password packet.
To set passwords for multiple rooms, the PMS must send a separate packet for each room.
Via Mailbox AdministrationThere is no option for setting the password via InnDesk (or the hospitality administration menus) but you can change it using Mailbox Administration. The password setting is found on the owner settings property page in the Mailbox Editor.
|